OK thanks, thats seemed to have worked (partly)
Using same settings (apart from SSID and Password of course) from here
https://www.thethingsnetwork.org/forum/t/wifi-config-on-a-multitech-mlinux-conduit/1244/6
ifconfig now lists wlan0
wlan0 Link encap:Ethernet HWaddr 74:DA:38:92:5C:F3
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1945 errors:0 dropped:173 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:288316 (281.5 KiB) TX bytes:1012 (1012.0 B)
and ifup wlan0 results in this
admin@mtcdt:~# ifup wlan0
udhcpc (v1.22.1) started
Sending discover…
Sending discover…
Sending discover…
Usage: /etc/udhcpc.d/lanup {bound|renew|deconfig}
run-parts: /etc/udhcpc.d/lanup exited with code 1
No lease, failing
admin@mtcdt:~#
I’m really an amateur at both Linux and the Multitech – any hints on what to check/change greatly appreciated.
cheers
Paul
edit: I am working on an AEP model if that makes a difference
-
This reply was modified 1 day, 14 hours ago by
Paul Stewart.
-
This reply was modified 1 day, 14 hours ago by
Paul Stewart.
