Reply To: Defining the TX channels for Mdot

Dear Mike and Jason,

Thanks for the prompt reply.
Suppose, i want Mdot to transmit at channel 865.2, 865.5, 865.8, 866.10, 866.40 only and receive window at frequency 866.70 or 867 only. How would i configure this ?

Can you provide insight on AT+CHM channel mask command for different possible parameter option? AT command guide has less info about this

Are the default 3 channels editable or they are always used?

By adding the above channels in the conduit,the added channels are sent down to endpoint in the join accept message.

So,for every session, we need to configure required channel and use save and restore options for every reset operation.

Thanks,
Suraj