Hello guys!
I’m struggling with sending message to specific mDot module in Peer to Peer mode of communication. I’ve configured three mDot modules with same settings for Peer to Peer mode, when one module sends message, other two receive that message, is there a way to send message to only specific mDot module?
On page 95 of AT command manual, it says
To allow
communication between mDots, configure two or more mDots with the same network settings.
But not explained how to send message to specific mDot, it seems to always send broadcast message.
If Peer to Peer mode can only send broadcast messages, is there any other mode that can send Unicast messages?
Thanks for your time and any help will be highly appreciated.
Farrukh