Reply To: RN2903A based device does not join (OTAA) Conduit AP anymore

Additional detail Multitech Support requested requested as follows for the reader of this article’s reference.
* Did not reconfigure the for ABP during manual add process – was throwing the kitchen sink at the problem at this stage.
* Experimental setup did change slightly between join and not join. Change deemed to be negligible as it was approx. 0.002 of observed effective end-device range. (e.g. if we’ve established reliable 1000 ft range, relative position changed by approximately 2 feet).
* We do not have Multitech end-devices to test with.
* I believe there is a firmware update available for the Microchip device. That being said, I’d still appreciate attention to the posted logs.
** Downgrading the Lora Network Server (LNS) did not have an effect. If it was a later conformancy issue, I’d expect join with earlier LNS versions.
* I don’t have access / tools to RN2903A logs / terminal output at the moment. Will try to get these if at all possible.