Hi Jason,
Thanks for reply, I guess you mean this page : “http://www.multitech.net/developer/software/lora/conduit-mlinux-convert-to-basic-packet-forwarder/” ? That’s a little bit poor…
I have tried to follow it, but it is not successful. When starting the packet forwarder (/etc/init.d/lora-packet-forwarder start), it seems to start but I’m not sure… which binary should be visible using the ps command ?
root@mtcdt:~# /etc/init.d/lora-packet-forwarder start
Found MTAC-LORA-868 with MTAC-LORA-1.0 hardware
Starting lora-packet-forwarder: OK
In fact I really wonder about the default installation of the Conduit: I have connected my computer to the Ethernet port, set up with static IP address. Impossible to ping the PC, impossible to ping the Conduit. Impossible to open an SSH session whereas it is said it is possible… I have sometimes the network interface up/down in the console, I don’t know why…. Finally set up with dhcp on my LAN, but how udhcpc can be launched ? Network always up/down in this configuration… not stable at all.
Version of my Conduit :
root@mtcdt:~# cat /etc/mlinux-version
mLinux 3.3.6
Built from branch: (detachedfromf4f803d)
Revision: f4f803d9bdab9aece5b101496cad97710f920246
So I was thinking to flash the Conduit with the factory installation. I’m familiar with Yocto but impossible to build because IT restrictions …. 
destiny is against me!
=> Any place I can get a full factory image of the Conduit with Ethernet working, SSH set up, packet forwarder inside, just with LORAWAN configuration to be finalized ?
Thanks for your help to every body,
Joel