I have two conduits, one of them is a Verizon specific conduit or rather works with that carrier and the other one seems to work with ATT.
I have a custom app that has been installed on the local flash of both the conduits and is re-prioritized to run before the lora-wan service. However when we power cycle the conduit, i.e by removing the power cord from the conduit and if I connect it back anything less than 30 seconds, on the Verizon conduit, the custom app fails to launch, even though the boot log clearly indicates that the custom app was started.
However the same scenario in my attempts to reproduce doesn’t occur on the conduit that supports the ATT carrier.
I am not sure what to make of it especially since the boot log indicates that that custom application was started successfully.
How best to troubleshoot the failure of launch of a custom app, since this app is very critical for it to run before node-red is up and running and its also a nodejs based application.
Thanks,
Ajay