I have enabled ADR on mdot using the API call m_dot->setAdr(true), and on the AEP model Conduit I have just used the default setting for the ADR. I am using the MTAC-LORA-915 card on the conduit. Is there anything else I need to do to support ADR?
1) The reason I ask, is that my mdot and conduit are just a few feet away and at this range, shouldn’t it be allowing me to send a payload at the max data rate allowed for US915 frequencies and not just 11 bytes which is least data rate and if I am guessing right is the SF_10 spread factor?
2) Also should I be setting any default data rate, even though I have setup ADR, such as the least TxDataRate in US is SF_10 spread factor?
3) I have set the transmission power to max allowable transmission power of 20dbm on the mdot.
4) Is there any conduit settings/mdot settings that I am missing, that I should enable in addition to the default settings for ADR?
Thanks,
Ajay